ARM Electronics Casino VCR800 - Manual (Page 22)

PLAYBACK
English-22
PLAYBACK MODE L8H L24H L40H 48 H 72 H 120 H 168 H 240H 480H 960 H
Audio playback Available Available Available Not Available Not Available Not Not Not Not Not
PLAYBACK MODE L3H L15H L27H 48 H 72 H 120H 168 H 240H 480H 960 H
Audio playback Available Available Available Not Available Not Available Not Not Not Not Not
Load a pre-recorded tape.
AUTO PLAY :If a cassette with the erasure prevention tab removed is loaded, the unit
automatically begins playback. 1
Press the PB / REC SPEED (+) or(–) buttons to select the desired playback mode. 2
Press the PLAY button to start playback. 3
Press the STOP button to stop playback. 4
AUDIO PLAYBACK
The modes with the letter “L” (i.e. L8H, L24H, L40H) are for audio recording and playback on
the linear track.
• NTSC
* Select the VIDEO setting on “SYSTEM
SET UP” menu to COLOR or B/W
according to the playback video signal
type.
* If too much noise appears in B/W
playback mode of B/W monitor, convert
to color mode. Then you can view more
clear picture.
NOTE
* When the picture shakes up and down
when above 24H, 40H of PLAYBACK, the
shaking can decrease by the control of
V. LOCK.(Refer to V. LOCK on page 27).
* There is normal sound playback only
when a tape recorded in theLinear REC
modes is played back in its respective
mode.
* If a recording is played back in a higher
REC/PB mode than it was recorded, the
picture will be played back in slow
motion, and if a recording is played back
in a lower mode than it was recorded,
the picture will be played back in fast
motion.
* The picture may move up / down or
noise may occur when the tape is played
back in time lapse modes, such as
L24H, L40H or longer.
NOTE
• PAL
1