ARAG DIGIWOLF - Power supply version 12V DC - Manual (Page 9)

9
3 CONTROlS IN THE mENU
0.0 l
2
1
0.0 l/min
SwITCH ON
The flowmeter is turned on when powered.
Press the key to see the succession of different values written in full (central part
of the display).
Whenever the device is switched on, it will briefly display its name and
software version.
0.0 l
2
1
0.0 l/min
ACCESS TO SETUP mENU
Press the keys for 2 seconds at the same time to access setup menu.
Setup menu
Calibration
Flowrate alarms
Display
A B
SElECTION AND ACCESS TO mENU ITEmS
A Press in succession to move through items (the selected item is highlighted with
a black band)
B Press to access the selected item
Three dots under an item show the presence of another setup menu.
Flowrate constant
Min value
Max value
C
1
50000
0123 0
B
D A
mODIFYING DATA
A Press to toggle from one digit to another
B Press in succession to modify the value of the digit highlighted by the cursor
C Press to confirm the change. The display goes back to the previous screen.
D Press to exit current page without confirming changes.
3.1 First switch on
At first switch on, DigiWolf will run a guided procedure to set the language, two units of measurement (flowrate and volume), and
the operating mode (filling or flowrate).
Press key to move between items, OK to save and move to the next setting, or ESC return to the previous setting.
Fig. 12
Fig. 13
Fig. 14
Fig. 15
CONTROLS