ARAG BRAVO DSB - Manual (Page 9)

6 checking the sYsteM Before use
Switch the device on and check that the LED’s are working correctly:
Move switch A (Control Panel) upward;
In this way Bravo DSB switches on and automatically executes self-diagnostics of the device,
causing the LED’s of the regulation valve simulator (O), the
PRESS function LED (M) and the
LOW BATT signal to flash.
6.1 Tests on valve-control signals
At this point, test the Bravo components, checking that each action of the computer causes the
corresponding LED on the control panel to light up.
coMPonent
BehAViour of Led
on BrAVo dsB
Action
GENERAL VALVE
Red LED Valve opening command
Green LED Valve closing command
LED off Not connected command
REGULATION VALVE
Red LED Increase in pressure command
Green LED Decrease in pressure command
LED off No command or not connected
SECTION VALVES
Red LED Valve opening command
Green LED Valve closing command
LED off Not connected command
FOAM MARKER
Green L LED Left side selection of foam marker
Green r LED Right side selection of foam marker
Tab. 5
9