Amer Networks SRPM12 - Manual (Page 19)

20
PoE System Setting:
Select “POE System Setting” to configure the System’s PoE threshold setting (Figure 21).
Figure 21 - PoE System Setting
System power Threshold: When the ratio of the power used to the total available system power exceeds
or falls below the System power Threshold, the Midspan will send a trap event to the Management Station.
Note: If the system cannot provide enough power to support all of the connected power devices,
the devices connected to the higher priority ports will be given power first. The lower the port
number, the higher the priority. Therefore, Port 1 has the highest priority, and Port 12 has the
lowest.
Status Page
The “Status” page (Figure 22) shows the current status of the Midspan. The information displayed
includes:
Product Name: The name of the Midspan.
Firmware Version: The current firmware version on the device.
Protocol Version: The version of the Midspan detection protocol used by the Web Management Utility.
IP Address: The IP address of the device.
Subnet Mask: The subnet mask of the device.
Default Gateway: The default gateway of the device.
Trap IP: The IP address that traps are sent to.
MAC Address: The MAC address of the device.
System Name: The system name used assigned by the network administrator to identify the device.
Location Name: The location of the device assigned by the network administrator.
Login Timeout (Minutes): The amount of time the user can be inactive before being automatically
logged out of the web interface.
System Up Time: The amount of time the device has been operational.
PoE Status: This table displays the same information displayed in the PoE Status page.
Click “Refresh” to update the information on the page.