EverFocus Day / Night Speed Dome Camera EPTZ 100 - Manual (Page 31)

EPTZ100_ma_en_rev03.doc
31
4.1.7 Scan
This menu contains all setup options for automatic dome modes such as autopan, preset tours and
pattern.
SCAN
AUTO PAN
ALL PRESET
GROUP SCAN
TOUR SCAN
PATROL
PATTERN
AUTO PAN
PAN/TILT This autopan mode performs pan and tilt movements between 2
points. The vertical movement will be processed in programmed
speed from start / end point, the resulting movement is shown if
the schema below:
START Left autopan limit. Move to the position and press
IRIS - to store the start point.
END Right autopan limit. Move to the position and press
IRIS - to store the end point.
SPEED Autopan speed, range from 2 (slowest) to 180
(fastest).
DWELL Dwell time at start and end position, adjustable
1~45 seconds.
RUN Autopan start (this function will close OSD menu)
RETURN Return to AUTO PAN menu.
PAN ONLY This autopan mode performs a horizontal movement between 2
points.
START Left autopan limit. Move to the position and press
IRIS - to store the start point.
END Right autopan limit. Move to the position and press
IRIS - to store the end point.
SPEED Autopan speed, range from 2 (slowest) to 180
(fastest)
DWELL Dwell time at start and end position, adjustable
1~45 seconds.
RUN Autopan start (this function will close OSD menu).