Alinco DJ-175 - Manual (Page 42)

8.Set Mode
8
42
8.3.1 Menu 1 Battery Save (BS) Function
This function prevents useless battery consumption by switching the power ON/OFF
at a fixed ratio if there is no key operation or receiving signal for a continuous period
of 5 seconds or more.
1. BS-1 is displayed on the LCD.
2. Rotate the dial to select BS-1, BS-2 or OFF.
BS-1 saves the more amount of battery but may cause slight delay on receiving. BS-2 allows
smoother communication but saves the less amount of battery. OFF cancels the BS function.
• The factory setting is BS-1.
• The Battery Save function is temporarily suspended when a key is operated or a
signal is received.
• Set this parameter OFF for packet operation.
• The display remain unchanged even the BS function is in the OFF cycle.
8.3.2 Menu 2 Timer/Busy Scan Setting
Select the scan-resume condition in this menu (page 30).
1. TIMER is displayed on the LCD.
2. Rotate the dial to select the scan-resume condition between TIMER and BUSY.
8.3.3 Menu 3 Beep Function
Select OFF to turn off all the beep sounds inclusive of alerting beeps.
1. BEP-ON is displayed on the LCD.
2. Rotate the dial to select the beep setting on and off.
8.3.4 Menu 4 Tone-Burst Frequency Setting
1. 1750 is displayed on the LCD.
2. Rotate the dial to select the tone-burst frequency.
1750 2100 1000 1450
(unit: Hz)
BEP-ON BEP-OF
TIMER BUSY
BS-1 BS-2 BS-OFF
Available Parameters 8.3