Alinco DJ-175 User Manual

Page 26

4.Basic Operation

4.5.2 Recalling a Memory Channel

1. Select the Memory mode by pressing the

key. "

" and channel number

appear on the display to indicate that the unit is in the Memory mode.

Repeat to switch between the Memory and VFO modes.

2. Select a memory channel.

Rotating the main dial will increase or decrease a memory channel number.

4.5.3 Deleting a Memory Channel

1. Select the Memory mode by pressing the

key.

2. Rotate the dial to select the memory channel No. that you wish to delete.

3. Press the FUNC key, and while

is displayed on the LCD, press the

key. A

beep sounds, then "

" flashes on the display.

4.5.4 Programming a Repeater-Access Function Setting

The "Repeater-Access" function is to set the desired shift and tone parameters to the

current operating frequency by just 2 key-touches.

Please set the parameters to be applied to the Repeater-Access function here.

1. Enter the Memory mode (by pressing the

key if necessary).

2. Rotate the dial to select MrpALLFRQ.

3. Set the most commonly used Repeater-Access parameters by referring to "Repeater-

Access" (page 40). The parameters that can be programmed in this memory are

marked * in the chart 4.5.5 on the next page. By activating the Repeater-Access

function these settings are applied to the operating frequency regardless of the

VFO/Memory/CALL modes, by temporary replacing the current parameters.

4. After programming is completed, press the FUNC key then press the

key

while MrpALL is displayed to store the edited parameters.

5. Rotate the dial to operate in the Memory mode by selecting channels or press the

key for VFO mode operation.

NOTE:

When "

" is flashing in step 3 (when the memory contents are displayed as is

on the display), it is still possible to cancel the operation by pressing the FUNC
key, and while

is displayed on the LCD, press the

key. After changing

channels or modes, this is no longer possible.

NOTE:

• You can not communicate in the

channel.

• The

channel is skipped during scanning. You can not delete or

convert this memory to other purposes.