Alinco DJ-175 - Manual (Page 27)

4.Basic Operation
4
27
4.5.5 Programmable Parameters in Memory Channels
The following parameters can be stored in each of the memory channels.
• Frequency • Offset frequency *
• Skip channel setting • Shift direction (+/-) *
• Busy channel lockout (BCLO) • Tone encoder frequency *
• Transmission power (H/M/L) • Tone decoder frequency *
• Battery save setting • Tone encoder/decoder setting (TSQ) *
• Clock Shift setting • DCS code *
• Alphanumeric channel tag • DCS setting *
This mode is used to recall a most frequently used memory channel (stored in MC
channel) with a single key-touch.
1. Press the key.
" " is displayed on the LCD, and the channel
programmed in MC is recalled.
2. Press the key again or the key in the
Call mode to return to original operating mode
(VFO/memory).
IMPORTANT NOTE:
• The dial and direct key-entry of frequency/memory channel are blocked in the
Call mode.
• It is possible to temporary change the offset and CTCSS/DCS related
parameters in the Call mode.
• The Scan function is deactivated in the Call mode.
• The CALL channel reprogramming is possible but it can't be deleted from the
memory channel mode.
Call-Channel Mode 4.6
NOTE:
Only parameters marked "*" are programmable in Repeater-Access function memory.