Airmar S61—Transom Mount User Manual
Installation instructions owner’s guide, Transom mount speed & temperature sensor, Models: s61, s63 applications

17
-0
32
-0
1 re
v.
0
2
04
/12
/11
Transom Mount
Speed & Temperature Sensor
Models: S61, S63
Applications
• Not recommended for boats with large inboard engine(s).
• Designed for operation from 1–50kn (1–58MPH).
• Fits transom angles from 13–20
°
(most powerboats and small
fiberglass and aluminum boats).
For all other transom angles (including 3
°
transoms on jet boats
and vessels with stepped or undercut transoms) a tapered
plastic, wood, or metal shim must be fabricated.
• S63 can be snapped onto a P37, P52 or P55 transducer.
Tools & Materials
Safety goggles
Dust mask
Scissors
Masking tape
Electric drill
Drill bit, hole saw or spade bit for:
Bracket holes
4mm, #23 or 9/64"
Fiberglass hull only
chamfer bit (preferred), 6mm or 1/4"
Transom hole (optional)
20mm or 13/16"
Cable clamp holes
3mm or 1/8"
Marine sealant (suitable for below waterline)
Screwdrivers
Putty knife
Pencil
Zip-ties
Water-based antifouling paint (mandatory in salt water)
Pretest
Connect the sensor to the instrument and spin the paddlewheel.
Check for a speed reading and the approximate air temperature. If
there is no reading(s) or it is inaccurate, check the connections
and repeat the test. If there is still no reading(s) or it is inaccurate,
return the product to your place of purchase.
Mounting Location
CAUTION: Do not mount in an area of turbulence or bubbles:
near water intake or discharge openings; behind strakes, struts,
fittings, or hull irregularities
CAUTION: Avoid mounting the sensor where the boat may be
supported during trailering, launching, hauling, or storage.
• For the best performance, the sensor must be in contact with
smooth water. To identify an area of clean water, observe the
water flow off the transom while the boat is underway.
• Mount the sensor as close to the centerline (keel) of the boat as
possible to ensure the sensor remains in the water when the
boat is turning.
• Single drive boat—Mount at least 75mm (3") beyond the
swing radius of the propeller (see Figure 1). The starboard side
where the propeller blades are moving downward is preferred.
• Twin drive boat—Mount the sensor between the drives.
• Stepped transom—Mount the sensor on the step.
S61 with
S63 with
Align the
template’s fold
line with the hull
bottom and fold
under the hull
Figure 1. Mounting location on single drive boat
75mm (3")
min. beyond
swing radius of
propeller
bracket
bracket
Follow the precautions below for optimal product
performance and to reduce the risk of property
damage, personal injury, and/or death.
WARNING: Always wear safety goggles and a dust
mask when installing
WARNING: When the boat is placed in the water,
immediately check for leaks around the screws and
any other holes drilled in the hull.
CAUTION: Never pull, carry, or hold the sensor by the
cable as this may sever internal connections.
CAUTION: Never strike the sensor.
CAUTION: Never use solvents. Cleaners, fuel, paint,
sealants, and other products may contain strong
solvents, such as acetone, which attack many plastics
greatly reducing their strength.
IMPORTANT: Please read the instructions completely
before proceeding with the installation. These
instructions supersede any other instructions in your
instrument manual if they differ.
INSTALLATION INSTRUCTIONS
OWNER’S GUIDE &
Record the information found on the cable tag for future reference.
Part No._________________Date___________