Airlink WLL013 - Manual (Page 25)

Chapter 3 Wireless LAN Monitor Utility
19
2. On the Wireless Networks tab, uncheck the Use Windows to configure my wireless
network settings box and click OK.
If you need to revert back to using Windows XP Wireless Zero Configuration Utility, just
go to the Wireless Networks tab and check the Use Windows to configure my wireless
network settings box and click OK.
Status
The Status tab displays the current status of your Wireless LAN Card. It also allows you to
re-configure the Wireless LAN Card setting. Even though you might have configured the
settings during the driver and utility installation, it is possible that you want to change your
operating mode between Infrastructure or Ad-Hoc mode and fine-tune other settings.
You can connect your computer to a network in one of the following two ways. Refer to
sequential sections for configuration:
Ad Hoc Connecting to other Wireless LAN Card equipped computers, forming a
wireless network.
Infrastructure Connecting to a wired/wireless network through an Access Point.