Airlink AME001 - Manual (Page 47)

External Modem User's Manual
46
Appendix C: Quick Reference
A Go On-line in Answer Mode
Bn Select Protocol to ITU-V.22 or Bell 212A
D Go On-line in Originate Mode
En Command Echo
Hn Hang Up
In Identification
Ln Control Speaker Volume
Mn Monitor Speaker On/Off
Nn Automode Enable
On Return to On-line Data Mode
P Set Pulse Dial as Default
Q Result Code Display
Sn Reading and Writing to S Registers
T Set Tone Dial as Default
Vn Select Word or Digit Result Codes
Wn Current Message Control
Xn Extended Result Codes
Zn Reset
&Cn Select DCD Options
&Dn Select DTR Options
&F Fetch Factory Configuration
&Gn Select Guard Tone
&Kn DTE/Modem Flow Control
&Pn Select Pulse Dial Make/Break Ratio
&Rn CTS Signal Select
&Sn DSR Option
&Un Protocol Selection
&V View Configuration Profiles
&Wn Store the Current Configuration to Nonvolatile RAM
&Yn
Select the Default Profile
&Zn Store Telephone Numbers (n=0 to 2)
*In Connect Speed Selection
*Gn User Abort Selection
*Hn Auto Retrain Selection
\Nn Operation Mode Control
\Vn Single Line Connect Message Enable
%Cn Enable/Disable Data Compression
@ Answer
, Pause
! Initiate a Hookflash
; Return to Command State after Dialing
^ Tone Control
P Pulse Dialing
S Dial a Stored Number
T Touchtone Dialing
W Wait for Dialtone
A/ Repeat Command
+++ Escape