beautypg.com

Cleaning and servicing – Empire Comfort Systems CHBR-16-3 User Manual

Page 15

background image

Page 15

16934-3-0806

Annual inspection and cleaning by your dealer or qualified

service technician is recommended to prevent malfunction and/or

sooting.
TURN OFF HEATER AND ALLOW TO COOL BEFORE

CLEANING.

Remove logs, handling carefully by holding gently at each end.

Gloves are recommended to prevent skin irritation from ceramic

fibers. If skin becomes irritated, wash gently with soap and water.

Refer to manual for correct log placement.
PERIODIC CLEANING – Refer to parts diagram for location

of items discussed below.

• Do not use cleaning fluid to clean logs or any part of

heater.

• Logs - brush with soft bristle brush or vacuum with brush

attachment.

• Remove loose particles and dust from the burner areas,

controls, piezo covers and grate. Don’t remove media from

inside burner box.

• Inspect and clean burner air intake hole. Remove lint or

particles with brush. Failure to keep air intake hole clean will

result in sooting and poor combustion.

ANNUAL CLEANING/INSPECTION – Refer to parts diagram

for location of items discussed below.
• Inspect and clean burner air intake hole. Remove lint or

particles with vacuum or brush. Failure to keep air intake

hole clean will result in sooting and poor combustion.

• Inspect and clean all burner ports.

• Inspect ODS pilot for operation and accumulation of lint at

air intake holes.

• Verify flame pattern and log placement for proper

operation.

• Verify smooth and responsive ignition of main burner.

• Check level of ceramic media in burner. Burner should be

full, up to the level of openings in burner top.

Attention: Ceramic media that is dislodged from burner box

during shipment can be replaced through openings in burner

top. If settling of ceramic media occurs during shipment an

additional bag of ceramic media, part number, 12389 can

be ordered from Empire Comfort Systems, Inc.

CLEANING AND SERVICING