AEC Self Cleaning Continuous Filters - Manual (Page 8)

Self Cleaning Continuous Filter Chapter 1: Safety 7
Self Cleaning Continuous Filter Safety Tags
Tag Description Tag Description
Read Operation &
Installation Manual High Voltage Inside
Enclosure
PE
Protected Earth
Ground
Earth Ground
Lifting Point
1-2 Warnings and Precautions
Our equipment is designed to provide safe and reliable operation when installed and operated
within design specifications, following national and local safety codes. This may include, but
is not limited to OSHA, NEC, CSA, SPI, and any other local, national and international
regulations.
To avoid possible personal injury or equipment damage when installing, operating, or
maintaining this equipment, use good judgment and follow these safe practices:
; Read and follow these operation and installation instructions when installing,
operating, and maintaining this equipment. If these instructions become
damaged or unreadable, additional copies are available from the manufacturer.
; Follow all SAFETY CODES.
; Wear SAFETY GLASSES and WORK GLOVES.
; Work only with approved tools and devices.
; Disconnect and/or lock out power before servicing or maintaining the equipment.
; Use care when LOADING, UNLOADING, RIGGING, or MOVING this
equipment.
; Operate this equipment within design specifications.
; OPEN, TAG, and LOCK ALL DISCONNECTS before working on equipment.
You should remove the fuses and carry them with you.
; Make sure the equipment and components are properly GROUNDED before you
switch on power.
; Use EXTREME CAUTION when working with the Self Cleaning Continuous
Filters. COMBUSTIBLE MATERIALS SHOULD NOT BE MIXED WITH
DUST GENERATED FROM THE GRINDING OF FERROUS METALS.
Static electricity discharge can cause ignition. Inert gas is necessary for some
applications.