ACTi Outdoor Hemispheric / Fisheye Dome on Straight Wall with Tilted Mount - Manual (Page 16)

www.acti.com
Installation Guide
16
Appendices
This section describes the procedures in preparing the external devices that you can connect to
the camera. The camera supports DC12V power input, Digital Input and Output (DI/DO) and
Audio Input and Output devices using the bundled terminal blocks. The use of these devices,
however, is optional.
Connecting a Power Adaptor (Optional)
The camera consumes 9.6W power when powered by a Power over Ethernet (PoE) switch that is
IEEE802.3af compliant. In case of using a non-PoE switch or your PoE switch has limited power
supply, you can purchase a power adaptor and directly connect the camera to a power outlet. The
power adaptor must be connected to the supplied terminal block before use.
To do this, follow the procedures below:
1. Loosen the screws of the 12V and GND pins of the power terminal block.
2. Take note that a standard power adaptor cable has two (2) different wires:
White stripe: Connects to 12V Pin
Connects to GND Pin