Westermo FD-80 - Manual (Page 16)

16 6630-2281
7.1.1 Basic configuration
Serial transfer > Transfer mode
Point – point
Select Transfer slave point to point mode, with serial
connection to one Fieldbus Adapter. The FD-80 will
initiate and begin continuous transfer of data with the
other Fieldbus Adapter.
Addressed slave Select Transfer slave in addressed mode, with connection
to one Fieldbus Adapter acting as transfer master.
The FD-80 will wait for received data (including address)
from the Fieldbus Adapter master and send back data
once.
Address Set this FD-80 Transfer mode address, in range 1–64.
Only needed when Addressed slave has been selected.
Profibus-DP > Profibus DP parameters
Profibus DP Address
Set this FD-80 Profibus DP address.
Number of I/O Modules Set the number of I/O modules used by this FD-80.
The used I/O modules will be from 1 up to the chosen
“Number of I/O Modules”.
I/O module 1–4 > I/O module 1
Data type
Select data type for I/O module 1.
Module type Select module type for I/O module 1.
Data length Set data length for I/O module 1. Note that data length
is related to data type. The byte has a length of 8 bit and
word has a length of 16 bits.
Identifier Show the resulting identifier in hex.
The same content for all I/O modules, 1 to 8. The used I/O modules will be from 1 and
up to the chosen “Number of I/O Modules”.