Westermo FD-80 - Manual (Page 11)

11 6630-2281
Modify configuration
Configurations are defined per device type. see “Functional description”, chapter 7.
FD-80 P Point to point (P)
FD-80 A Addressed (A)
Load configuration to FD-80
• The present configuration, shown by FD-Tool, will be loaded to the FD-80 by selecting
File > Configuration > Load to device.
• This loaded configuration will be used by the FD-80 after a new power on.
6.4.3 Off-line configuration by FD-Tool
This part will only describe the usage of FD-Tool to perform an off-line configuration.
For FD-Tool installation and general FD-Tool handling, see “FD-Tool installation
manual.”
Initiate a new off-line configuration
• Start the FD-Tool.
• Select the device type by selecting File > Configuration > New (default / device) and
Select Group in the Device Selection window.
Note: The selected device must be the same as the FD-80 device, for which the configu-
ration will be used.
• Now the FD-Tool will show the device type of this FD-80 for which all configuration
parameters have to be set.
Modify configuration
Configurations are defined per device type. see “Functional description”, chapter 7.
FD-80 P Point to point (P)
FD-80 A Addressed (A)
Load configuration to FD-10
See, “On-line configuration by FD-Tool”, chapter 6.4.2.
6.4.4 Save, load and modify configuration files by FD-Tool
Save configuration to disk
• The present configuration can be saved to disk as a file, to be used for future
configurations of the same device type, by selecting
File > Configuration > Save to disk
• An arbitrary file name can be used, saved as a *.cnf file.
Load and modify a disk stored configuration
• Load configuration from disk by selecting Configuration > Load from disk and open
the required configuration file (*.cnf).
• FD-Tool shows the device type of this FD-80 with the present configuration.