Westermo FD-80 User Manual
Page 12
12
6630-2281
6.4.5 Ethernet network configuration by using Telnet
The FD-80 is always available for configuration of the TCP/IP protocol settings, by using
the Telnet network protocol. The default setting of FD-80 service port, for configuration
by using Telnet is:
IP-address 10.0.0.10
Subnet mask 255.0.0.0
Port number 1111
To select the configuration menu, start the Telnet client and use the parameters above,
e.g. under the DOS prompt enter Telnet
When the connection has been established you will see the following menu in your
Telnet window:
************************
* MINI Com-Server *
************************
1. INFO System
2. SETUP System
3. SETUP Port 0 (Serial)
4. Save Setup
Only one level at a time is shown on the monitor; enter a digit to scroll forward and
press ENTER to move backwards. All settings are activated only after a Save Setup. If
closing the Telnet connection without saving, the FD-80 retains all the settings it had
before opening the configuration menu. The following is an overview of the required
selections to be used by FD-80. The use of these selections are device and mode
dependent, to be described in chapters as follows:
FD-80 P Ethernet slave, Point to point continuously transfer mode
See chapter 6.4.6
FD-80 P Ethernet slave, Point to point addressed mode
See chapter 6.4.7
FD-80 A Ethernet master, addressed mode
See chapter 6.4.8
6.4.5.1 Selections, used by FD-80
SETUP System > Setup TCP/IP
IP-Address
IP-address setting of FD-80.
Subnet Mask
Subnet mask of the subnet in which the FD-80 is located.
Gateway
IP-address of the Gateway, used to get connections from FD-80 to
other subnets.
SETUP Port 0 (Serial) > Port State
Connection State
Online control about the configured TCP/IP mode of the Ethernet
network connection. For access to FD-Tool it must be in mode
FREE, otherwise it has to be device and application dependent.
Clear Port Mode
Revert the port to standard TCP/IP mode, FREE. This setting is
effective without Save Setup after exiting the menu.