Emerson EWC09D5 - Manual (Page 16)

– 16 – EN – 16 – – 16 – – 16 –
CHANNEL RESETTING
Make sure ...
• The unit power must be turned on.
RESETTING CHANNELS
1
Select “CHANNEL SET UP”
Hit [SETUP] on the remote control.
Press [K / L] to point to “CHAN-
NEL SET UP”, then hit [ENTER].
2
Begin auto preset
Press [K / L] to point to “AUTO PRESET”, then hit
[ENTER].
The tuner scans and memorizes all the active chan-
nels in your area.
NOTES:
• The unit distinguishes between standard TV chan-
nels and cable(CATV) channels.
• The unit may memorize TV chan-
nels as CATV channels if recep-
tion conditions is poor. If this
happens, try “AUTO PRESET”
action again when reception con-
ditions are better.
3
After scanning
The tuner stops on the lowest memorized channel.
TV
- TV SETUP -
B CHANNEL SET UP
LANGUAGE [ENGLISH]
– CHANNEL SET UP –
ADD / DELETE CH (TV)
B AUTO PRESET
ADDING/DELETING CHANNELS
The channels you no longer receive or seldom watch
can be deleted from the memory. (Of course, you can
add the deleted channel into the memory again.)
1
Select “CHANNEL SET UP”
Hit [SETUP].
Press [K / L] to point to “CHAN-
NEL SET UP”, then hit [ENTER].
2
Select “ADD/DELETE CH”
Press [K / L] to point to
“ADD/DELETE CH”, then hit
[ENTER].
3
Enter the desired channel number
Press [K / L] until your desired
channel number appears (You can
also use the Number buttons or
[CH. K / L] to enter it).
4
Delete (or add) it from (into) memory
Hit [ENTER]. The channel number changes to light
red. The channel is deleted from memory.
• To delete another channel, repeat steps 3 and 4.
• If you hit [ENTER] again, the channel is memo-
rized again.
5
Exit the channel setup mode
Hit [SETUP] to exit the menu.
NOTE:
• To confirm that channel(s) has been deleted or
added, hit [CH. K
K / L L ].
Added channel: Light blue.
Deleted channel: Light red.
- TV SETUP -
B CHANNEL SET UP
LANGUAGE [ENGLISH]
– CHANNEL SET UP –
B ADD / DELETE CH (TV)
AUTO PRESET
08
ADD / DELETE
(Example: CH8)