Emerson EWC09D5 - Manual (Page 14)

– 14 – EN – 14 – – 14 – – 14 – – 14 – – 14 –
SET UP FOR THE
FIRST TIME
1
Plug in the unit power cord
Plug the unit power cord into a standard
AC outlet.
NOTE:
• If some digits appear in the corner of
the screen, hit [POWER] without
unplugging the power cord.
2
Turn on the unit
Hit [POWER] to turn on the unit.
3
Select the On Screen Language
Press [K / L] to point to “LAN-
GUAGE”, then hit [ENTER] to
select “ENGLISH” or
“ESP”=Spanish or “FRA” =French.
“[ ]” indicate the selected language.
4
Begin auto preset
Press [K / L] to point to “AUTO
PRESET”, then hit [ENTER].
The tuner scans and memorizes all
active channels in your area.
NOTES:
• The unit distinguishes between
standard TV channels and cable (CATV) channels.
• The unit may memorize TV channels as CATV
channels if reception condition is poor. If this hap-
pens, try “AUTO PRESET” action again when
reception conditions are better. Refer to “CHAN-
NEL RESETTING” on page 16.
5
After scanning
The tuner stops on the lowest memorized channel.
You can select the desired channel directly with the
Number buttons or [CH. K / L].
NOTE:
• Channel memory programming is NOT needed
when connected to a cable box or satellite box. Just
select the unit channel selector to the output chan-
nel of the cable box or satellite box (Ex CH3).
Then select the channel to be viewed on the Cable
Box or Satellite Box.
TV
– SET UP –
B LANGUAGE
[ENGLISH] ESP
FRA
AUTO PRESET
– SET UP –
LANGUAGE
[ENGLISH] ESP
FRA
B AUTO PRESET
TV OPERATION AND SETTINGS
WATCHING A TV PROGRAM
1
Turn on the unit
Hit [POWER] to turn on the unit.
2 Select the channel number
Press [CH. K / L] to select your desired channel
number or press the Number buttons.
Note for using the Number buttons:
¡ When selecting cable channels which are higher
than 99, hit +100 first, then press the last two dig-
its. (Example: to select channel 125, first hit
[+100] then hit [2] and [5]).
¡ You must precede single-digit channel numbers
with a zero (For example: 02, 03, 04 and so on).
3
Adjust sound
Press [VOL. X / Y] to adjust the volume.
Hit [MUTE] to instantly mute the sound.
Hit it again to restore the previous sound level.
NOTE:
• If you press [CH. K / L] in the
DVD mode, you can change the
TV channels.
Even if you turn off the unit in the
DVD mode, when you turn it on
again, it will go into the TV
mode.
TV
VOLUME 20
C C C C C C C C C C C C C C C C
TO WATCH CABLE OR SATELLITE
CHANNEL
• If the unit is connected to a cable box or satellite
box, press [CH. K / L] to select CH3 or CH4
according to the output channel setting of the
device, and select desired channel on that device.
TO WATCH EXTERNAL INPUT
• When an external equipment is connected to the
front AUDIO/VIDEO input jacks, press [SELECT]
or [CH. K / L] repeatedly until “AUX” appears on
the screen.
TV SECTION