Emerson EWC09D5 - Manual (Page 10)

– 10 – EN – 10 –
NOTE:
•
Before plugging the an antenna into the ANT. jack of the unit, check that the
pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin
into the ANT. jack of the unit.
– 10 – – 10 –
PREPARATION FOR USE
ANTENNA/CABLE CONNECTION
The Indoor Antenna (supplied) is detachable. Insert the stem of the antenna into the
hole on the upper-back portion of the unit. Connect the Indoor Antenna to the unit
as shown in the diagram. For the best reception, fully extend the Indoor Antenna
and make the necessary adjustments. (Avoid touching the top section when adjust-
ing.)
NOTE:
• The connection of an Indoor antenna may not always give acceptable TV
reception.
CABLE WITHOUT CONVERTER/
DESCRAMBLER BOX
Use this connection if your cable system connects
directly to the unit without a converter box.
CABLE WITH CONVERTER/DESCRAM-
BLER BOX OR SATELLITE BOX
If your cable service supplies you with a converter
box or if you use a satellite system, you can use the
basic connection shown above.
Channel selection must be made with the converter
box or satellite box. This means that channels cannot
be changed using the remote control of this unit.
Bent pin
Cable
Plug
(Needs to be straightened)(Straight pin)
UHF
VHF
VHF/UHF
VHF
or
UHF
VHF
or
UHF
DC 13.2V
COAXIAL
ANT.
ANT.
OUT IN
VHF/UHF COMBINED ANTENNA
A VHF UHF 75 ohm combination antenna can be
connected to ANT. jack of the unit.
VHF/UHF SEPARATE ANTENNAS
In some areas it will be necessary to use an outdoor
antenna.
INDOOR ANTENNA
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding
system of the building as close to the point of cable entry as practical.
[Fig. 5]
Indoor Antenna
(Supplied)
Flat twin-lead cable
DC 13.2V
COAXIAL
ANT.
ANT.
Matching
Adapter
(Supplied)
VHF/UHF
Combiner
Flat twin-
lead cable
From Cable System
75-ohm
Coaxial Cable
CATV Box or
Satellite Box *
From Cable System or
Satellite Antenna
[Fig. 4]
OR
OR
[ANTENNA CONNECTION] [CATV/SATELLITE CONNECTION]
* Some cable TV systems use scrambled signals and
require a special converter to receive these channels.
Consult your local cable company.
Adaptor
75-ohm
Coaxial Cable
NOTE:
• For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack
before moving the unit.
Cables used here are commercially available.