Epson ELP-3000 - Manual (Page 76)

Replacing the Fuse
When you need to replace the fuse, use only a 250 V, 6.3 AT fuse appropriate for
your voltage.
Follow these steps:
1. Turn off the projector and disconnect the power cord from both the back of
the projector and the wall outlet.
2. Turn the projector so its back panel is facing you. The fuse holder is located
below the power switch.
3. Remove the fuse holder by inserting a screwdriver or similar object into the
groove. Then pry out the holder.
Replacing the Fuse
n n n n n n
61