Extron electronic Low Profile Floor-Mount Raceway System for A/V Connectivity AVTrac - Manual (Page 15)

Installation
AVTrac • Installation 13
Step 4: AAPs
At this point, the track, ramps and connectivitly box must all be securely in place, and the AC power module must be
attached to the connectivity box and connected to an AC junction box.
To attach the Architectural Adapter Plates (AAPs), follow these instructions:
4-1 Fill the remaining AAP slots with seven spaces of
AAPs.
In models without the AC power module, fill all ten spaces
of AAPs.
4-2 Run the cables from the wall to the connectivity box.
Attach the cables to the AAPs as described in the
installation guide for each AAP module.
Install AAPs
Run cable to AAPs
2.88" (7.30 cm)
2.50" (6.30 cm)
N To prevent bending of cables, place the
AAP with the greatest depth requirement
(including cables) in the AAP slot closest to
the center ridge of the connectivity box.
End Plate
End Plate
Cover
Openings for
AAPs
AC Outlet
Cover Plate
RGB 580x i SI AAP
CO MP UTE R AUD IO
H SHI FT INP UT SEL ECT
AAP
4-3 Reattach the end plates and cover panel.
End Plate
End Plate
Cover
AAPs RGB 58 0xi SI AAP
COMPUT
ER AUDI O
H SHIFT INPUT SELEC T
N Extron AAPs must be purchased separately.