WattMaster WCC III part 12 - Manual (Page 2)

TABLE OF CONTENTS
SECTION 12:
WCC III INSTALLATION GUIDE
WCC III System Requirements ................. 12-1
MCD Basic Operating Conditions ............. 12-2
Wall Mounting of the WCC III – MCD ......... 12-2
WCC III – MCD Internet Access ................ 12-4
Sending a Text Message to a
Cell Phone via an Email from
the WCC III System ................................... 12-6
WCC III System RS-485 Communication
Wiring ........................................................ 12-7
WCC III - MCD Typical System
Architecture .............................................. 12-8
Mounting a Satellite Controller in an
Enclosure ................................................ 12-10
Satellite Controllers -
General Dimensions ............................... 12-15
SAT III Controller - LED Information ....... 12-16
SAT III Controller - Connection Points ... 12-17
Addressing (Numbering) of
SAT III Controllers .................................. 12-19
SAT III Relay Outputs ............................. 12-21
Proportional-Integral (PI) Output
Board ....................................................... 12-24
Binary Input with Time Delay Board ...... 12-27
V-Out Binary/Relay Interface Board ....... 12-34
SAT III Analog Inputs .............................. 12-41
SAT 3C Controller .................................. 12-49
Addressing the SAT 3C ........................... 12-51
Addressing (Numbering) of the
TUC/RTU Controllers that are
Connected to the SAT 3C ....................... 12-53
SAT 3D Controller ................................... 12-57
Addressing the SAT 3D ........................... 12-58
Addressing (Numbering) of the TUC
Controllers that are Connected to the
SAT 3D ..................................................... 12-60
SAT 3F Controller .................................... 12-62
Addressing the SAT 3F ........................... 12-63
Addressing (Numbering) of the TUC
Controllers that are connected to
the SAT 3F ............................................... 12-65
TUC-2R and Four Relay Expansion
Board ...................................................... 12-67
TUC-2R Three Relay Expansion Board
and Damper Actuator .............................. 12-68
TUC-2R Velocity Sensor ......................... 12-69
Running the WCC3 Program ................... 12-70
WCC III - MCD LCD Display ..................... 12-73
The WCC III - MCD ................................... 12-78
Using the MCD-Menu Program ............... 12-79