4 daily use, 1 starting-up and running, 2 placing the product container – Watson-Marlow PD12 IHS User Manual
Page 8: Daily use, Starting-up and running, Placing the product container, Instruction handbook
INSTRUCTION HANDBOOK
PD12IHS / PD12IDH
PD12IHS_PD12IDH IH EN 74-115-181 v2.00.doc
Version: 2.00
Page 8 of 19
4 Daily Use
4.1 Starting-up and running
Installation section must be carried out before this chapter can be performed.
4.2 Placing the product container
In order to build up adequate pressure, it is recommendable to place the product container at the
same level as dispenser head or preferably above the dispenser head level. Placing the container
higher than dispenser head level provides positive product support and may reduce the calibration
interval. It is also recommended to place the container as close as possible to the dispenser on
suction side.
Flexicon
Pump Head
Preferred Placement
of container
Normal Placement
of container
Suction side
Pressure side
Fig. 5 - placing the product container
Dispenser head