Watson-Marlow 605Di - Manual (Page 13)

12
Pumphead spares
Number Spare Description Number Spare Description
1 GR 0008 Grommet 8 MRA0010A Rotor assembly
2 MR 0258M Guard 9 SG 0003 Spring
3 SW 0139 Guard switch & magnet 10 MR 0572T Roller - guide
4 MR 0601T Collet 11 MRA0161A Track assembly
5 MR 0571T Roller - tube 12 MR0275M Hinge - guard
6 MR 0575T Roller - tube guide XX 0095 Teflon lubricant
7 MR 0573T Spindle
605L Pumphead
The twin offset track design of the 605L utilises 4.0mm wall double-Y tube elements to overcome pulsation for accurate dosing and
dispensing. The 605L accepts Silicone and Marprene tubing up to 16.0mm bore. Use 4.0mm wall tube for transfer for the highest
performance and improved viscous fluid handling.
Alternatively the 605L will run with two separate tubes although some channel to channel variance and minimal pulsation may be
experienced. For separate tube fitting or twin tube inlet to single tube outlet fitting tube clamping blocks must be used.
605L Installation
Remove the mounting plate cover and track from the 605L. Align the drive shaft dog and 605L centre shaft slot. Locate 605L to
pump. Tighten top and bottom mounting plate screws. To remove the pumphead lift off the mounting plate cover and track, loosen
the to and botton mounting plate securing screws and ease pumphead away from the pump.