Watson-Marlow MR-Series - Manual (Page 25)

Revision 1.4 / August 2013 Visit our website at www.masosine.com 25
How to use the Removal Tools
Removal tools are supplied with every new MasoSine Pump. The tools are shaped like skate blades
and have a pin extending from one end (see
Figure 14 ). These tools are used for removing the rear liner
and the seal housing
FRONT VIEW SIDE
VIEW
Figure 14 – Removal Tools
To use the tool remove the seal housing from the pump, simply insert the pin at the end of the tool into
the hole on the outer diameter of the seal housing (see
Figure 15 ). Two holes have been drilled in the
seal housing, 180° apart, to facilitate the use of both tools. By applying downward pressure to the
hooked ends of the tools, the seal housing will be pulled from the rear of the pump housing. Always
use both tools when removing the seal housing to prevent it from wedging in the pump housing.
Figure 15 – Remove the Seal Housing