Visara 1330-X02 - Manual (Page 24)

2-10 701333-004
Preparing to Operate the 1330
Connecting a Parallel or Serial Cable
To comply with FCC regulations, use one of the following cables:
• Parallel cable – MTX P/N 956588-001 (36-pin, 6 ft. EIA).
• RS-232 serial cable – This is available as P/N 957520-010 (10 feet). For other RS-232
or RS-422 applications, use locally available cables.
Before you connect the cable, make sure the Power switch is in the O (OFF) position.
Connecting a Parallel Cable
Push the male end of the parallel cable into the parallel receptacle on the back of the
1330 (see Figure 2-9). Push the wire guards, located at each end of the receptacle, in,
over the cable end, to hold the cable in place.
Connecting a Serial Cable
Loosen the screws at each end of the serial receptacle on the back of the 1330 (see Figure
2-9). Push the male end of the serial cable into the serial receptacle. Tighten the screws
to hold the cable in place.
Wire Guards
Parallel Receptacle
Serial Receptacle
Screws
Figure 2-9. Connecting a Parallel or Serial Cable