Visara 1199-C16 - Manual (Page 10)

2-4 707025-004
Chapter 2: Customer Installation
Communications Cabling
The 1199-C16/32 Multiplexer supports only coaxial cable type BNC connectors for
connection to the Communications Server. The device port connectors are Dual Purpose
Connectors (DPC) permitting the attachment of coaxial cable and/or twisted pair type
transmission media.
1199-C16/32 Rack Mounting
The 1199-C16/32 Multiplexers are designed with holes to mount them in a standard
equipment rack. Four holes are provided for rack mounting. Refer to Figure 2-2.
Figure 2-2. Front view 1199-C16/32, Rack Mounting
Device Connection
Ensure the multiplexer is within reach of an acceptable AC power receptacle. There is no
power switch on the unit. Connecting the multiplexer to an AC power source is the last
step in installation. When plugged in, the green power LED on the back panel lights,
indicating power is applied and the unit is on.
Connect the multiplexer in the following manner.
1. Connect the transmission cable from the Communications Server (this must be a
multiplexed output port) to the BNC connector at the top right back on the
multiplexer.
2. Connect the associated devices to the connectors labeled 0 through 15 on the
1199-C16, or 0 through 31 on the 1199-C32.
3. Plug the equipment side of the power cord into the multiplexer power receptacle.
4. Plug the voltage side of the power cord into an appropriate AC power outlet. The
installation of the multiplexer is now complete.
4 Rack mounting holes