Verilink SCC 2130 (880-503282-001) Product Manual - Manual (Page 42)

Configuration
3-22 Verilink SCC 2130 User Manual
numbered as 14 and the last slot 26. In a node consisting of all
Dual-line shelves, the first (left-hand) slot of a second shelf is
number 03.
2. Rapidly press the EXE pushbutton twice, as if double-clicking a
mouse. If the SCC 2130 accepts your double-click, the STAT
LED on the selected module will begin to blink green to off. If
the STAT LED does not begin to blink try double clicking again
at a slightly faster or slower rate. Do not proceed to step 3
until the STAT LED on the desired module begins to blink.
Once the STAT LED does begin to blink, steps 3 and 4 must be
completed within 60 seconds or the thumbwheel command
procedure will time-out.
3. Set the thumbwheel switches to the command value which is
to be used, per Table 3-8 below.
4. Double-click the EXE pushbutton again. If the SCC 2130
module accepts your double-click, the STAT LED on the
selected module will stop blinking green to off and return to
some other state. If the STAT LED on the module continues to
blink green to off, the SCC 2130 did not accept your double-
click. Try double-clicking again, at a faster or slower rate. If
you are not successful within 60 seconds of the time you
selected the module in step 2, the module will timeout and
return to it’s normal state. If this happens, start over.
Thumbwheel
Commands
The chart in Table 3-8 lists the commands available through the
front panel thumbwheels.
Table 3-8 Thumbwheel Switch Commands
Code Applies to Description
01 to 30 Any of first
30
modules
Selects a module in the indicated slot, up to slot 30. Thumbwheel
switches cannot be used for modules in slots 31-52
31 SCC 2130 Access the controller functionality of the SCC 2130 node controller
(not the T1 IDCSU portion). For an SCC 2130 in slot 1 of shelf 1, use
address 01 to set IDCSU options
32 SCC 2130 Reset modem interface by sending the configured modem
initialization string to the DB-9 SLIP port (use only with 31, as in
31/32)
40 TAC 2010 Canned configuration #1, EQPT=SF/AMI NET=ESF/AMI
41 TAC 2010 Canned configuration #2, EQPT=ESF/AMI NET=ESF/AMI
42 TAC 2010 Canned configuration #3, EQPT=SF/AMI NET=ESF/B8ZS
43 TAC 2010 Canned configuration #4, EQPT=SF/B8ZS NET=ESF/B8ZS
44 TAC 2010 Canned configuration #5, EQPT=ESF/B8ZS NET=ESF/B8ZS