Verilink SCC 2130 (880-503282-001) Product Manual - Manual (Page 15)

Verilink SCC 2130 User Manual 2-1
Chapter
2
Quick Set-Up
This section details a quick, step-by-step procedure for configuring
the SCC 2130. For the purpose of this quick configuration guide,
these assumptions are made:
• That you are using the SCC 2130 with a fractional ESF/B8ZS T1
circuit.
• That timeslots one through twelve are to be used for the one
available data port.
• That you are using a Cisco™ 4000 series router for the
purpose of connecting to the Internet.
Figure 2-1 Example Configuration
It is most likely that this procedure will not match your
configuration exactly. Use this chapter as a guide to the process of
installing your equipment. Complete details on configuration
covering all selectable options may be found in
Chapter 3 .
Connect to Craft
Port
Using the Craft cable supplied with the SCC 2130, connect the
modular (RJ-11) end to the port labeled Craft on the front panel of
the SCC 2130. Connect the other end of the Craft cable to your PC
or terminal. If your PC has a DB-9 COM port connector, use a
standard PC-AT serial cable to complete the connection.
Set your terminal, or terminal program, to 19.2 kbit/s, 8 data bits,
no parity, one stop bit and no flow control.