Verilink PRISM 3301 (34-00239.5) Product Manual - Manual (Page 25)

Configuration Commands 17
SET NET AIS TX-XBIT
This command sets the AIS TX-Xbit option. The choices are 0 and 1.
SET DTE RATE
This command configures the High-speed Serial Interface (HSSI) data rate. The
DTE rate is usually set with the SET MAP command.
3 - 3.158 Mbps
6 - 6.316 Mbps
12 - 12.631 Mbps
18 - 18.947 Mbps
25 - 25.263 Mbps
31 - 31.578 Mbps
37 - 37.894 Mbps
44 - 44.210 Mbps
SET DTE CA
This command indicates what error conditions send a signal to the DTE.
LOS (Loss of Signal)
OOF (Out Of Frame)
RXAIS (Receive AIS signal)
RXYELLOW (Receive Yellow alarm).
SET DSU
Primary: T3 signals to/from the network are routed to the HSSI DTE port and the
auxiliary connectors located on the front of the unit are disconnected.
Secondary: Hands off the T3 signals to and from the network to a separate PRISM
3301. The HSSI DTE port becomes inactive.
SET MAP
This command assigns the M-frame timeslots (1 –7). This command uses the
format ,-.
SET SUPERVISORY MODE
This command configures the supervisory port mode to either Direct or Modem.
SET SUPERVISORY BAUD
This command configures the supervisory port baud rate to 1.2, 2.4, 4.8, 9.6, 19.2 kbps.
SET SUPERVISORY COA
This command enables the Call-Out on Alarm (COA). The choices are On and Off.