Verilink PRISM 3301 (34-00239.5) Product Manual User Manual
Verilink Computer hardware
Table of contents
Document Outline
- Front Matter
- About This Guide
- 1. General
- 2. Installation
- 3. Front Panel Interface
- 4. Terminal Interface
- Modem Compatibility
- Interface Start-up
- Configuration Commands
- Set Commands
- SET NET LBO
- SET NET YELLOW-X-BIT
- SET NET AIS PATTERN
- SET NET AIS RX-STUFFING
- SET NET AIS TX-XBIT
- SET DTE RATE
- SET DTE CA
- SET DSU
- SET MAP
- SET SUPERVISORY MODE
- SET SUPERVISORY BAUD
- SET SUPERVISORY COA
- SET SUPERVISORY DIAL-STRING
- SET SUPERVISORY HANGUP-STRING
- SET SUPERVISORY INIT-STRING
- SET SLIP
- SET SLIP MODE
- SET SLIP BAUD
- SET SLIP DIAL-STRING
- SET SLIP HANGUP-STRING
- SET SLIP INIT-STRING
- SET SLIP FILTER
- SET SLIP UNIT-ADDRESS
- SET SLIP SUBNET-MASK
- SET SLIP ROUTER-ADDRESS
- SET SNMP READ-COMMUNITY
- SET SNMP WRITE-COMMUNITY
- SET SNMP TRAP
- SET SNMP SYSTEM
- SET SCRAMBLER
- SET PROGRAM EPROM
- SET PROGRAM EPROM
- SET ADMINISTRATION PASSWORD {password} NAME {name} LEVEL {1,2,3}
- SET ADMINISTRATION PASSWORD {password} DELETE
- SET ADMINISTRATION PASSWORD {password} CHANGE
- SET ADMINISTRATION TOD
- SET ADMINISTRATION UNITID
- SET ADMINISTRATION CIRCUIT
- SET ADMINISTRATION APPLICATION
- SET AUDIBLE
- SET DATALINK EIC
- SET DATALINK LIC
- SET DATALINK FIC
- SET DATALINK UIC
- SET DATALINK PATH-MESSAGE
- SET DATALINK IDLE-MESSAGE
- SET DATALINK TEST-MESSAGE
- SET DATALINK TERMINAL DTE
- SET DATALINK TERMINAL CARRIER
- Get Commands
- Query Commands
- Test Commands
- Reset Commands
- Reboot Commands
- Set Commands
- Appd. A. MIB Reference
- Appd. B. Ordering Information and Optional Equipment