Start test, Reset errors, Pattern sync – Verilink PRISM 3010 Dual DSX-1 (34-00250.2) Product Manual User Manual
Page 19: Elapsed time, Bit errors, Errored seconds, Configuration screen
Configuration Screen 13
Start Test.
Pressing Enter with the cursor on the (START TEST) option starts the
selected test pattern. TEST IN PROGRESS appears once the test has started. To
end the test, press Enter on STOP TEST.
Reset Errors.
Pressing Enter with the cursor clears the test error results.
The following fields are for display only. They reflect the selected test parameters
and the results of these tests only.
Pattern Sync.
Displays the current state of pattern sync during a test. If no test is
in progress, NO TEST is displayed. If a test is active, but the receiver is not in
pattern sync, NO SYNC is displayed. If the receiver is in pattern sync, IN SYNC is
displayed.
Elapsed Time.
Displays the time elapsed since a timed test began or, if completed,
the total test time.
Bit Errors.
Displays the total number of bit errors detected since the test began or
since error statistics were cleared (up to 999,999).
Errored Seconds.
Displays the number of asynchronous errored seconds that have
been detected since the test began or since error statistics were last cleared. This
parameter includes bit error seconds and sync loss seconds.
% EFS.
This ratio is derived from the number of error-free seconds divided by the
number of seconds accumulated in Elapsed Time.
Configuration
Screen
The Dual DSX Configuration screen (Figure 4-6) allows viewing and setting
configuration parameters for the Dual DSX unit.
Figure 3-13 Dual DSX Configuration Screen
To send a new configuration to the unit, press Enter on one of the fields or exit the
screen. The underlined values are the factory default parameters stored in ROM.
3030 DSU x.xx/x.xx
PRISM 3030 Date:
MM/DD/YY
3030 DSU x.xx/x.xx
(Unit Address: 23)
Time: HH:MM:SS
--------------------------- DUAL DSX CONFIGURATION -----------------------------
222222
2+2+2+
333333
11111+
Channel Allocation:
AAAAAA
BXBXBX
ABCDEF
*****R
Signalling Enabled:
------
------
------
------
Port #:
[4A ]
Framing:
[D4 ]
Line Code:
[AMI ]
DSX Level:
[0-110 FEET ]
Channel:
[1 ]
Setting:
[IDLE]
Signalling:
[DISABLE]
Alarm on LOS/OOF:
[DISABLE]
------------------------------------Messages------------------------------------
✍