Dukane 8914 - Manual (Page 6)

4
Y
VIDEO
RGB IN1 RGB IN2
RGB OUT CONTROL
AUDIO 1-IN
S-VIDEO
COMPONENT VIDEO
C B /P B C R /P R
R-AUDIO 2-L
AUDIO-OUT
Part names
Lens (  16)
Filter cover ( 
9,40)
(Air fi lter and intake vent
are inside.)
Elevator button (  8)
Elevator foot (  8)
Remote sensor (  15)
Zoom knob ( Zoom knob (  18))
Focus ring ( Focus ring ( 
18))
Vent ( 
6)
AC inlet (  13)
Power switch (  16)
Elevator button (  8)
COMPONENT
VIDEO ports (  12)
Y
C
B
/P
B
C
R
/P
R
S-VIDEO port (  12)
VIDEO port (  12) CONTROL port (  11)
Part names
Projector
Lamp cover ( 
39)
(Lamp unit is inside.)
Elevator foot (  8)
Bottom side
Front-Right side
Rear-Left side
Control buttons (  5)
(See the following page.)
Ports (See below.)
Vent ( 
6)
AUDIO-OUT port (  11)
Ports
AUDIO 1-IN port (  11)
AUDIO 2 L/R port (  12)
RGB IN1 port (  11)
RGB IN2 port (  11)
NOTE (*) About Restart switch: This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
Speaker
Restart switch (*) (  46)
RGB OUT port (  11)