Upsite 10132 RAM Kit 90 Extrusion & Sealing Membrane - Manual (Page 4)

4
888.982.7800
www.upsite.com
Installation Guide
HotLok ® Rack Airflow Management Kit
Installation Procedures
3. Sealing Membrane installation for both internal and external Mounting Extrusions.
a. Start the sealing membrane into the retention clip using one corner and then press along the length of the
mounting extrusion to insert the full length of the membrane.
i. Helpful Hint: Take small sections at a time to help push into the extrusion
ii: Alternate Assembly: The Sealing Membrane can be inserted into the Mounting Extrusion before plac-
ing inside of the cabinet. This may require good spacing of the Mounting Extrusions on the sealing membrane.
b. The Sealing Membrane should rest flush with the rack system, with no gaps, to minimize airflow inside of the
rack system.
c. If your Sealing Membrane is not sitting flush due to an obtrusion, obstacle and/or notch, it may be helpful to
cut the membrane around the obstruction or attempt to work out the “kinks” by repositioning the Sealing Membrane in
the Mounting Extrusion. Additionally, the double sided adhesive can be used to secure the membrane to adjacent parts.