Upsite 10132 RAM Kit 90 Extrusion & Sealing Membrane - Manual (Page 2)

2
888.982.7800
www.upsite.com
Installation Guide
HotLok ® Rack Airflow Management Kit
Tools Required for Installation
• For cutting the Mounting Extrusions, you will need a chop saw, miter saw, tin snips or other cutting
instrument
• For cutting the sealing membrane, you will need scissors, box cutter or a sharp blade
• Tape measure
Preparation Required For Installation
1. Determine the best method to customize your data rack.
a. No external lip will require internal installation of Mounting Extrusions to the inside panel
or side wall of the rack system using the supplied double sided adhesive.
b. External “lip” on the rack system allows for clip-on method to the extended or protruding
area on the rack.
2. For the Mounting Extrusions, use the tape measure to take measurements for the internal/exter-
nal area where the mounting extrusions will be placed (sides, top and bottom of rack). Measure
around any obstacles, mounting brackets or interferences, as you will place Mounting Extrusions
around these on the rack systems.
3. Cut the Mounting Extrusions to your size specifications.
4. For the Sealing Membrane, measure the area where the Membrane will be placed.
a. Special Note: Measure the length, top and bottom and add 1/2 to 1 inch to measurement
for extra material. The corner areas will be addressed in the installation.
b. Cut out any special notches, customized to your rack system as needed.
Profiles - Mounting Extrusion Profiles - Sealing Membrane
Part No. 10132 90 º Profile @ 105’ Part No. 10139 2.5” Wide Roll @ 100’
Part No. 10134 45 º Profile @ 105’ Part No. 10140 4.0” Wide Roll @ 100’
Part No. 10141 5.5” Wide Roll @ 100’
Note: 105 feet (32m) of Profile is provided in fifteen 7 foot (2.1m) long pieces. Sealing panel material is provided in the
selected width (2.5”, 4.0” or 5.5”) in a single 100 foot (30.5m) long roll. Extrusion Profile and Sealing Membrane sold
separately.