Upsite 20101 Wave Cover - Manual (Page 4)

Installation Procedures
Installation of KoldLok Wave™ on the Tile Interior
1. Make a 9 1/4 x 6 3/4 ” (± 1/8”) cutout or 235mm x 171mm (± 3mm) in the floor
tile. A cutout template is available for download at www.KoldLokWave.com.
Ensure that any burrs that resulted from cutting the floor tile have been
removed. It is not necessary to dress the cutout when installing a KoldLok
Wave™ Split Integral grommet.
2. Test-fit KoldLok Wave™ to
the floor tile by making
the flange flush with the
top side of the floor tile.
Ensure there is no binding
and that the fit is even on
the grommet.
3. With the grommet
properly placed in the
floor tile, fasten it securely
to the floor tile using the
self-tapping screws. Do
not over-torque the
screws.
Assembling Grommet Around Cable Bundles
1. Separate KoldLok Wave™ unit at the seam by sliding the female side
up off of the male side.
2. Place male section on the floor, back edge first.
3. Re-assemble unit at the seam around cables following the above
installation instructions.
Joining clip fits into matching
pockets on both halves
Tapered pin fits into tapered
hole on opposing part
Male Female