Triplett CamView W35v – PN: 8055 - Manual (Page 13)

Page 12
• Plug the charger into the power source (wall outlet) then plug
the charger cable into the connector (7) on the side of the product.
twice slowly (as the product tests the batteries) then turn on solidly
quickly, there is a problem with the batteries. They may be installed
incorrectly, there may be a bad connection, or one or more of the
batteries are defective.
• When the red LED turns off the batteries are close to being fully
charged. 10 minutes of additional charging time will fully charge the
batteries. Usually, the batteries can be fully charged in 1.5 hours or
less. It is normal for the batteries to warm up when charging.
• The batteries will not charge if the temperature is too low (below 32
degrees F).
Replace the battery cover and reposi- -