Tri Tool 301 Tube Squaring - Manual (Page 10)

10
TRI TOOL INC.
92-0630 Rev. 130308
NOTE:
NOTE:
MAINTENANCE
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter.
If the Model 301 is operated in the vertical position (Cutting Head up), it should be
turned upside down and the chips and/or other debris removed after each bevel has
been completed.
Tool life may be severely shortened, unless chips and/or other debris that
have been deposited on the Cutting Head during the machining operation are
removed.
Disassembly of a power unit voids warranty, except when performed by a
TRI TOOL Inc. designated repair technician.
Clean-Up