Tri Tool 224B Miter Mandrel - Manual (Page 9)

9
Org 990702
Model 224B Miter Mandrel Head
Occasionally back off the four parallel offset adjustment screws, remove the Draw
Nut, Adaptor Plate Assembly and the Torque Plate.
Check all parts for cracks, burrs, etc.
Remove the four Angular Offset Adjustment Screws and Spherical Washers and
separate the Gimbal Plate from the Mandrel Head.
Check the spherical bearing surface for burrs and/or other defects.
Do not reuse any part that shows evidence of cracking, bending or over stressing.
Apply a very thin coat of general purpose grease or anti-seize to the spherical
surface of the gimbal plate, two or three drops of light oil on each of the four spheri-
cal washers, grease or anti-seize to both sides of the torque plate and grease,
anti-seize or oil to all screws, nuts and threads. Reassemble in the reverse order
of disassembly.