Tri Tool 224B Miter Mandrel User Manual
Page 17
17
Org 990702
Model 224B Miter Mandrel Head
NOTE:
It is highly desirable to mount the Miter Head so that the Angular Offset Pivot point
is on the same plane with the proposed finished wall preparation.
This will diminish the amount of parallel offset required after the angular adjust-
ment has been made.
Using a tape measure or steel rule, keep the rear flange of the Gimbal Plate roughly
centered while turning the Jackscrews to tighten them against the ID of the
workpiece.
Use the wrenches provided to tighten all (8) eight Jackscrews securely.
Mount the Indicator Sleeve to the Adaptor Plate Assembly and tighten the Mount-
ing Nut.
Place the Magnetic Based Indicator Holder onto the Sleeve and energize the mag-
net.
Instillation of the Indicator Sleeve Assembly.
Final Face Line
Angular Offset
Pivot Point
Adaptor Plate
Assembly
Mounting
Nut
Indicator Sleeve
Assembly
Workpiece
- 204B Cutting Head (9 pages)
- 204B Cutting Head (10 pages)
- 204B Cutting Head (9 pages)
- 212B Single Point Spring Hanger Assembly (8 pages)
- 204B Cutting Head (13 pages)
- 204B Cutting Head (36 pages)
- 204B Cutting Head (17 pages)
- 201BA Beveler (36 pages)
- 204B Elbow Mandrel (16 pages)
- 204B Beveler (45 pages)
- 204B Flange Facer (21 pages)
- 206B Elbow Mandrel (17 pages)
- 206B Flange Facer (22 pages)
- 206B Beveler (45 pages)
- 212B ID Tracking Module (17 pages)
- 206B Miter Mandrel (16 pages)
- 206B Sleeve Mandrel (13 pages)
- 208B Elbow Mandrel (20 pages)
- 208B ID Tracking Module (18 pages)
- 208B Miter Mandrel (20 pages)
- 208B Flange Facer (28 pages)
- 208B Sleeve Mandrel (15 pages)
- 212B Elbow Mandrel (16 pages)
- 214B Beveler Single Point Flange Facer (41 pages)
- 212B Flange Facer (22 pages)
- 212B Miter Mandrel (20 pages)
- 212B Single Point Hydraulic Motor Assembly (9 pages)
- 212B Single Point Flange Facer Miter Mandrel (28 pages)
- 212B Sleeve Mandrel (12 pages)
- 214B Elbow Mandrel (20 pages)
- 214B Flange Facer (23 pages)
- 214B ID Track Module (19 pages)
- 214B Miter Mandrel Head Kit (22 pages)
- 214B Sleeve Mandrel (13 pages)
- 236B ID Tracking Module (23 pages)
- 224B Single Point (30 pages)
- 230B Beveler Flange Facer (16 pages)
- 230B ID Tracking Module (15 pages)
- 230B Lifting Frame (19 pages)
- 236B Miter Mandrel (25 pages)
- 301SP Tube Squaring (35 pages)
- 236B Single Point (32 pages)
- 302 Tube Squaring Micro Feed Assembly (11 pages)
- 302 Tube Squaring (31 pages)