Tri Tool 212B Single Point Flange Facer Miter Mandrel - Manual (Page 18)

18
TRI TOOL INC.
92-0738 : Rev. 980331
Remove the indicator items and the Indicator Sleeve from the Miter Head.
Tighten the Draw Nut securely.
Torque should be 50 ft/lbs (68 N/m) to 75 ft/lbs (102 N/m).
Align the torque pin holes in the end of the Mandrel Shaft with the Torque Pins in the
Adapter Plate Assembly.
Install the Mandrel Shaft Assembly onto the Adapter Plate Assembly and tighten the
Draw Rod to 75 ft/lbs (102 N/m) to 100 ft/lbs (136 N/m).
At this time the Miter Mandrel should feel absolutely tight and rigid.
Before installing the Model 212B BEVELMASTER™ be sure to read the Operator’s
Manual, giving special attention to all safety cautions and warnings.
212B Miter Mandrel, Short Perch Tool Holder Extension Adapter
In the case of a short perch mounting application, like short elbows from 8” pipe to
16” pipe, a tool holder extension adapter (P/N 27-0626 and P/N 33-2123) is used to
Installation of the Indicator Sleeve Assembly