Tri Tool 212B Single Point Flange Facer Miter Mandrel - Manual (Page 17)

17
Model 212B Miter Mandrel Head for SP/FF
92-0738 : Rev. 980331
As before, use the Indicator Kit to determine how much the Adapter Plate Assembly
must move, and in what direction.
To move the Adapter Plate Assembly in a given direction, first loosen one or two
Parallel Offset Adjustment Screws on the side of the Adapter Plate Assembly which
you wish to move toward.
Now tighten the Screws on the side of the Adapter Plate Assembly which you wish to
move away from in order to push the Adapter Plate Assembly in a given direction.
NOTE: Never exceed 30 ft/lbs (41 N/m) of torque on the Parallel Offset
Adjustment Screws.
Repeat the indicating procedure and the Parallel Offset adjusting procedure as
many times as necessary to achieve the accuracy desired.
Once the accuracy requirements have been satisfied, evenly tighten all four (4)
Parallel Offset Adjusting Screws.
Recheck the adjustment with the Indicator Sleeve.
Dial Indicator Kit Setup