Tri Tool 212B Single Point Flange Facer Miter Mandrel - Manual (Page 10)

10
TRI TOOL INC.
92-0738 : Rev. 980331
Identification of Various Major Parts
Occasionally back off the four (4) Parallel Offset Adjustment Screws, remove the
Draw Nut, Adapter Plate Assembly and the Torque Plate.
Check all parts for cracks, burrs, etc.
Remove the four (4) Angular Offset Adjusting Screws and Spherical Washers and
separate the Gimbal Plate from the Mandrel Head.
Check the spherical bearing surface for burrs and other defects.
Do not reuse any parts that show evidence of cracking, bending or over stressing.
Apply a very thin film of general purpose grease or anti-seize to the spherical
surface of the Gimbel Plate, two or three drops of light oil on each of the four (4)
Spherical Washers, grease or anti-seize to both sides of the Torque Plate and
grease and anti-seize or oil to all screws, nuts and threads. Reassemble in the
reverse order of disassembly.