Tri Tool 212B Single Point Flange Facer Miter Mandrel - Manual (Page 14)

14
TRI TOOL INC.
92-0738 : Rev. 980331
If it is not, then loosen the Angular Offset Adjustment Screws where the gap is
small and tighten the Angular Offset Adjustment Screws where the gap is
wide.
Lightly tighten the Draw Nut.
NOTE: All four of the Angular Offset Adjustment Screws must be used in
conjunction with each other.
All Screws must be at least slightly loose to allow movement.
If the Mandrel shaft is to be drawn directly toward one screw, the opposite
screw must be loosened far enough to allow for the take up before the near
screw is tightened.
Leave the Draw Nut slightly loose during and after the Angular Offset adjustment.
Check to see that the Adapter Plate Assembly is centered to the Gimbal Plate.
Parallel Offset
Adjustment