Tri Tool 208B Flange Facer - Manual (Page 23)

23
Model 208B FF (Flange Facer)
92-1495 : Orig. 100728
Problem: The Tool Holder is Not Feeding
The feed pin is broken or out of position.
The feed sprocket shear pin is broken.
The feed screw is stripped.
The feed nut is stripped.
The slide rails are too tight.
Problem: There’s a Loss of Air Power
The air supply pressure is too low.
The air filter is plugged.
The air line size is insufficient.
The air line is too long.
Problem: The Air Motor Will Not Start
The air power supply is shut off.
The air motor is damaged and will not run free.
The air motor needs lubrication.
Add lubrication and do not run the air motor for a few minutes, then try run-
ning the motor.
Tap on the side of the air motor casing lightly with a piece of wood or with a
soft rubber mallet just in case the vanes may be sticking.
Sand or other foreign material may be in the vanes of the air motor.
Problem: There’s a Loss of Hydraulic Power
The hydraulic supply pressure is too low.
The hydraulic filter is plugged.
The hydraulic line size is insufficient.
The hydraulic line is too long.
Problem: The Hydraulic Motor Will Not Start
The hydraulic power supply is shut off.
The hydraulic motor is damaged and will not run free.