Tri Tool 208B Flange Facer - Manual (Page 13)

13
Model 208B FF (Flange Facer)
92-1495 : Orig. 100728
Tool Bit Installation
To select the appropriate tool bit(s) refer to the “Tool Bits” section of this
manual.
Use of dull or improperly designed tool bits or tool bits not manufactured by
tri tool inc may result in poor performance and may constitute abuse of this
machine and therefore voids the tri tool inc factory warranty.
Slide the tool bit into the tool bit holder slot on the tool block.
Lock the tool bit position with the set screws on the side of the tool block.
Lock the mandrel in place using the mandrel lock set screw located in the
back of the handle feed plate.
Tool life may be severely shorted, unless the chips/debris deposited on the
cutting head during the operation are removed.
To avoid tool bit damage, the tool bit must clear the highest point of the
flange on the first revolution.
Damaged or worn tool bits are evident by increased feed pressure, visual
observations, poor surface finish, etc.
Check the position of the Tripper Shaft for Feed Rate.