Tri Tool 208B Flange Facer - Manual (Page 15)

15
Model 208B FF (Flange Facer)
92-1495 : Orig. 100728
OPERATION
Position and clamp the Model 208B to the ID of the pipe.
Attach the power supply line to the Model 208B.
Turn the motor on and use the manual feed to advance the tool bit to the flange of
the pipe.
The actual machining operation will begin when the cutting surface of the tool bit
comes in contact with the flange.
If the pipe is out of round, the cutting will contact only a small segment of the flange
during each revolution.
Location of the Tripper Blocks
Tripper Block