Tri Tool 206B Flange Facer - Manual (Page 12)

12
TRI TOOL INC.
92-0214 : Rev. 920331
Location of the Tripper Block and the Feed Handle
POSITIONING OF THE TOOL HOLDER
Turn the Feed Sprocket clockwise to feed the Tool Holder in. (Refer to the picture
“Location of the various Screws”).
Tool Holder feed travel is from O.D. to I.D.
ADJUSTMENT OF THE TOOL BLOCK
Loosen the hold-down Screws on the Adjustable Slide Rail.
Run the Tool Holder to the most outward position.
Using the Adjustment Set Screws, apply a light force to the side of the Adjustable
Slide Rail so that it is in positive contact with the Tool Holder.
Adjust only those Screws which bear directly in line with the Tool Holder.
Tighten the Hold Down Screws to about 12 to 24 in-lbs. (1.4 to 2.7 N-m). (Finger
tight using a hex key).
Using the 1/4” Drive Ratchet, run the Tool Holder to the inward most position.
Note any changes in the feed pressure.
Some drag from the Slide Rails should be felt, but only a very light torque should be
required to move the Tool Holder.