Tri Tool 206B Flange Facer - Manual (Page 10)

10
TRI TOOL INC.
92-0214 : Rev. 920331
OPERATION
Positioning the Model 206B in a tube or pipe
Read the operating instructions carefully before attempting to operate the Model
206B-FF.
Use eye protection at all times when operating the Model 206B-FF.
Configure the machine for the proper task. (Refer to the Model 206B Operator’s
Manual.)
Attach the Model 206B-FF to the Model 206B. (Refer to the chapter “Attaching the
Model 206B-FF to the Model 206B”.)
Position and clamp the Model 206B to the I.D. of the pipe.
Check for the proper position of the Tool Holder. (Refer to “Positioning of the Tool
Holder” later in this chapter.)
Check for the proper position of the Tool Bit to the flange. (Refer to “To adjust the
depth of cut of the Tool Bit…” later in this chapter.)
Check the position of the Tripper Shaft for feed rate. (Refer to “Feed Rate” later in
this chapter.)
Attach the proper power supply line to the Model 206B.